Future revisions of ISO will accommodate changes in technology affecting test dust manufacturing processes and insure product consistency for years. ISO A2 Fine Test Dust Particle Size Distributions (Volume % Less Than). size. ISO A2 Fine. – – – ISO Road vehicles – Test contaminants for filter evaluation – Part 1: Arizona test dust.
|Published (Last):||5 January 2005|
|PDF File Size:||18.41 Mb|
|ePub File Size:||2.1 Mb|
|Price:||Free* [*Free Regsitration Required]|
Although it is not currently specified as a suitable contaminant for cabin air filters, it is used as a 12130-1 contaminant for fuel system components, water filter performance evaluation, and other custom applications. Sold in gram net weight quantities b Packaging can be customized to accommodate the larger quantity ieo c Bulk Density: Particle counting is a mainstay of contamination control in hydraulic, automotive, and aerospace applications.
Particle size limits specified per ISO are expressed as cumulative volume percent smaller than and listed as follows: The Multisizer IIe analyzer measures particles individually by volume mass. The nominal specific gravity is 2. The small particle procedure, using fine dust is performed to ascertain the ability of equipment to resist the effects of fine particles which may penetrate into cracks, crevices, bearings, and joints.
Certified and reference values for the cumulative number of dust particles per unit volume of hydraulic oil greater than the specified particle diameter are reported.
Test Sand & Test Dust
A view of volume differential particle size data indicates a bi-modal distribution with approximate peaks at 4 and 20 micron size. Share this product Tweet. Particles for analysis are suspended in an electrolyte solution. The suspension is stirred and drawn through an aperture using a vacuum source. Particles are measured as they pass through the aperture. Samples from only two batches were used because only two batches of this type dust were produced prior to when ISO particle size limits were determined.
It specifies four grades of test dust including dust 1213-1, designation, particle size distribution, particle size analysis procedure, and chemical content. RoomBuilding 5, No. The bi-modal aspect of this product traces back to the original roller analysis specification of Fine Test Dust shown in former revisions of SAE J Specification.
Four grades of test dust are designated in ISOa description of each is as follows: The intent in producing a separate standard for the description of test dust was to provide a simple and accurate test dust reference for use in other standards or documents where test dust use is required.
Consists of 20 grams of dry dust taken from the same lot as the dust in SRMand is provided with reference values from 1 micron to 50 microns. Future revisions of ISO will accommodate changes in technology affecting test dust manufacturing processes and insure product consistency for years to come.
It was originally developed for testing automotive kso air filters. Particle sizes greater than 30 microns are given as reference values. Shanghai Jun Yu Trade Co. Standard Materials for Calibration. West Coast Sales Sparks Blvd.
Test Sand & Test Dust
A naturally occurring irregularly shaped mineral dust suspended in hydraulic oil at a nominal concentration of 2. Material Safety Data Sheet.
To the best of our knowledge since we are an active global distributor of all test dust and sands, ISO test dust is a non- contaminant and non-hazardous Class 60 material. Certified values for particles sizes from 1 micron to 30 microns are provided.