Manuals or user guides for your HP DesignJet T in Printer. HP DesignJet T and T Printer Series. Using your The only warranties for HP products and services are set .. Web Services manual configuration. Service Manual and more parts for CRA DesignJet t in eprinter.

Author: Gom Kanos
Country: Malawi
Language: English (Spanish)
Genre: Technology
Published (Last): 7 April 2008
Pages: 423
PDF File Size: 8.63 Mb
ePub File Size: 9.22 Mb
ISBN: 187-5-17881-926-5
Downloads: 75495
Price: Free* [*Free Regsitration Required]
Uploader: Zolosho

Use the Arrow keys to choose roll or sheet paper. Cut the cable tie that fixes the ferrite on to the Data Harness. The product performs a series of movements to test the primer.

Remove a printhead by lifting up the blue handle.

If HP is asked to replace such parts, the customer will be charged for travel and labor costs. Allow the Pinchwheel Alignment Tool to expand. CH Foot Assembly includes 2 feet.

Unclip and remove the cable clamp of the Trailing Cables. Open the Carriage Cover. The Touch Control Panel will then show the test results.

Spindle Removal Open the roll cover. Secure Disk Wipe provides three different levels of security: The product will scan the Calibration Pattern which could take several minutes. Please use the product number and serial numbers of the new product to validate warranty status.


HP Designjet T790 / T1300 / T2300 series. Service Manual

These settings include many different fields, such as IP address and subnet mask, available gateways, host and domain names, etc. If the values are not within the range specified, an error appears on the Touch Control Panel. Grip the motor housing of the Media Advance Drive and gently pull it towards you sufficiently to allow you disengage the Media Advance Drive from the product.

Press Cancel to exit the utility.

HP DesignJet T1300 44-in Printer User Guides

In order to align ayou need a minimum one correctly aligned by the manufacturer. Ferrite Data Harness C.

See Tools 1 on page Tools 2 on page Fit the new bumpers into place. Remove Media from the paper path.

Lift the Formatter out of the product. Page Open the Carriage Cover.

HP DesignJet T in Printer User Guides | HP® Customer Support

Detach both cable branches from their holders. Remove the Latch Hook. Remove the USB Host cable from the clamps. Paper Path Asse mblies Front on page While securing the screw with a 10 mm wrench key, use an 8 mm wrench to tighten the nut. Removal of the other two sections is done in the same way. Page Hold the calibration sheet from both sides and place it facing the arrow in the centre of the sheet in front of the Page icon present on the input tray of the scanner.


Carriage PCA on page This procedure tests only the formatter, as the other subsystems such as the PSU or Engine PCA are tested during the Initialization of the product every time the unit is switched on. Readership The procedures described in this Service Manual are to be performed by HP Certified service personnel only. If the calibration was successful, a message appears such as the following. The new print information overwrites the old information. Page 70 Problem Description: Unclip the cable holder from underneath the primer do not discard it as the part will be reused.

Remove the Pinchwheel Alignment Tool from the product. Roll Cover, Lower Removal Open the lower roll cover.