Information you will need about your DSL-GT Wireless ADSL Router: D- Link ADSL devices incorporate the recommendations of the ADSL Forum. Modem Dlink DSLT/T/T/GT/GT – Bootloader ADAM2 . Manuale firmware Acorp (v. manuale ) -> Download. D-Link DSL B3 User , , M. [ ], D-Link DSL Manuale Router DLink DSL-GT – , , M.
|Published (Last):||21 June 2007|
|PDF File Size:||7.84 Mb|
|ePub File Size:||16.71 Mb|
|Price:||Free* [*Free Regsitration Required]|
Only a single filter is required. Most users will not need to change these settings. Page 9 Page 10 – Information you will need about your lan The Administrator Settings window is the first item in the Tools directory. Firmware X-link Performing a Firmware Upgrade can sometimes change the configuration settings.
Type the lowest numbered port in the range in the Port Start space. Community Traps Filters Filter rules in the Router are put in place to allow or block specified traffic. To modify any previously created filter rule, click on the note pad icon in the right hand column of the Filter List for the set you want to configure.
To remove any MAC address from the list, click the radio button in the left column of the list for the MAC address to be removed and click the Apply button. Got it, continue to print.
Click on the Properties button. The pre-configured rules include those listed in the table here: Firewall The Firewall Configuration window allows the Router to enforce specific predefined policies intended to protect against certain common types of attacks.
If you wish to return to the previous window during the setup process, click the Back button.
D-Link DSL-G624T User Manual
Page of Go. The window will display settings that are appropriate for the connection type you select.
Page 66 The PVC pull-down menu offers eight virtual connections available for configuration. The levels available are: The diagnostics feature executes a series of test of your system software and hardware connections.
Click the Next button to proceed.
This is used to specify that all packets destined for a particular network or subnet use a predetermined gateway. First determine the direction of the traffic you want the rule to filter.
Click Network and Internet Connections. Firmware Performing a Firmware Upgrade can sometimes change the configuration settings. The manuqle are configured for individual devices based on MAC address.
D-Link DSL-GT User Manual – Page 1 of |
You will need to supply the IP addres, Subnet mask and Defualt Key length is outlined at the bottom of the window. Table of Contents Add to my manuals Add. Don’t have an account? This IP address is not protected by NAT and will therefore be visible to agents on the Internet with the right type of software.
After compiling the list of MAC addresses as desired, click the Apply button to enforce access control for the MAC addresses in the list. Windows 95 and Windows 98 First, check for the IP protocol and, if necessary, install it: For applications or circumstances where packet loss or packet delay is a concern, ATM QoS can be adjusted to minimize problems. Filter rules can be set up for source, destination or both.
Upon restarting the Router will automatically establish the WAN connection. Wireless Performance Wireless Performance If you want to tweek wireless settings, click the Wireless Performance window button in the Advanced directory It is recommended for most users to use the default Wireless LAN Performance settings. See the previous chapter for a description of the Home directory windows.
Introduction This section provides a brief description of the Router, its associated technologies, and a list of Router features.
Manyale Management Wireless Management The Wireless Management window located in the Advanced directory is used to control MAC address access to the wireless access point and to view a list of MAC addresses that are currently associated with the access point.