ASTM A/AM Direct No.: + Fax No.: + Email: [email protected] Board No.: + ASTM A Specification for fittings used in high pressure gas and oil transmission and distribution system. Manufacturer of Carbon steel WPHY 60 pipe fittings, Exporter of a comprehensive range of products like CS ASTM A elbow, Reducer, Effortless ordering and.
|Published (Last):||23 October 2017|
|PDF File Size:||17.41 Mb|
|ePub File Size:||18.60 Mb|
|Price:||Free* [*Free Regsitration Required]|
Fittings shall subsequently be heat treat edby normalizingquenchingand. Users of this standard are expressly advised that determination of the validity of any such patent rights, and the risk of infringement of such rights, are entirely their own responsibility. Section V, Nondestructive Examination.
If you want to use it ,you can buy from following link: Within the text, the SI units are shown in brackets. Rejection and Rehearing JIS G Carbon steel pipes for high pressure service. ASTM International takes no position respecting the validity of any patent rights asserted in connection with any item mentioned in this standard.
A806 G Arc welded carbon steel pipes.
A860 WPHY 65 PIPE FITTTINGS
If used on small? Other imperfections shall be treated in accordance with After the removal of s860 cracksthe tees shall be re- examined by the removal of any Acceptable tees shall be marked with the symbol PT or MTas applicableto indicate compliance.
Materials and Manufacture 5. BoxArlingate Ln. These fittings are for use in. JIS G Carbon steel pipes for pressure service. This specification covers wrought high-strength low-alloy butt-welding steel fittings of seamless and electric fusion-welded construction for applications in high-pressure gas and oil transmission and distribution systems. And over, Sizes tested Section;min, specimen, thickness [7.
The nickel content of the deposited weld metal shall not exceed 1. In case of con? JIS G Carbon steel pipes for ordinary piping. This does not preclude the use of deoxidizers. The results shall conform to Table 1 for either heat or Speci?
Carbon steel WPHY 65 buttweld fittings, ASTM A WPHY GR 65 Pipe Fittings Manufacturer, Exporter.
The nickel content of the deposited weld metal. Within the text, the SI units are shown in brackets.
The nickel content of the deposited weld metal shall not exceed 1. No cracks shall be permitted. Current edition approved Nov.
ASTM A WPHY GR 60 Pipe Fittings, Carbon steel WPHY 60 buttweld fittings Manufacturer, Exporter.
Link to Active This link will astk route to the current Active version of the standard. Electrodes for the shielded metal-arc process shall be of the low-hydrogen type. Fittings formed above the transformation temperature or upon which welding is performed, shall be cooled to below the lower critical temperature prior to heat treatment. Width of specimen 11?
After the removal of any cracks, the tees shall be re-examined by the original method. Rejection shall be reported to the producer or supplier promptly in writing.
A860 WPHY 60 PIPE FITTTINGS
These fittings are for use in high-pressure gas and oil transmission and distribution systems. Starting materials shall consist of plate, sheet, forgings, forging quality bar, and seamless or fusion-welded tubular products with filler metal added.
Only the ultimate tensile strength need meet the minimum requirement of Table 2. No cracks shall be permitted. JIS G Carbon steel pipes for high temperature service. A refers to the high yield strength of the fittings.